How To Build a Pine Shed
Pine Harbor Shed Co.

Download the Complete Post and Beam Shed Plans & Buyer's Guide

7. Roof Sheathing:
The roof is sheathed with 5/8" CDX plywood. Nail the roof plywood with 8d nails every 16" along the rafters.

Start the first sheet flush with the outside edge of an end rafter, and flush with the ends of all the rafters it covers.

Before you nail the sheet of plywood, check the measurements in between the rafters at the top edge of the plywood. Make sure they are still 24" apart or ( 2 feet on center) before you nail off the plywood.

8. Trim - Corner Boards and Fascia:
First we do the corner boards on the gable ends of the shed. These are the four longer 1" x 4" pieces with a square cut on each end. Nail all the trim on with 8d nails.

Install the gable end corner boards flush with the boarding on the front and back sides of the shed.

Make sure the corner boards are also flush with the bottom edge of the boards before you nail.

Nail the gable end corner boards with 2 nails every 16"
Note: Try to nail your vertical trim in a consistent horizontal pattern with the nails in the boarding.

The fascia boards are the 1" x 5" pieces with square cuts on each end.

Next are the fascia boards. These are installed covering the rafter tails flush with the top of the roof sheathing and flush with the corner boards on the gable ends.

Nail the fascia boards on with 2 nails into each rafter tail

Next are the front and back side corner boards. Nail these on flush with the gable end corner boards and tight to the fascia boards at the top.

Notice how the corner boards and the batten strips are installed tight to the fascia board.

How To Build a Pine Shed Pine Harbor Shed Co.

How To Build a Pine Shed
Pine Harbor Shed Co.